resetrsa command

Use the resetrsa command to reset the Remote Supervisor Adapter or Remote Supervisor Adapter II to the default settings and then restart it. This command is for BIOS-based servers only.

This command takes approximately 30 seconds to complete.


The syntax of the resetrsa command is
asu resetrsa [-nx]
Note: If the optional -nx parameter is specified, the ASU performs the operation for node x, where x is the selected node in a multi-node system. Node x can be a number from 1 through 8. If the -nx parameter is not specified, the operation is performed on the primary node (node 1).


The output of the resetrsa command is a message that indicates that the restart of the Remote Supervisor Adapter is completed.

The following example shows the resetrsa command and corresponding output.

Command line:
 asu resetrsa
Rebooting RSA/RSA2...done