The Array.letter parameter
specifies how many arrays are created and the physical drives to include
in each array. You can specify the physical drives through any of
the following methods:
The channel number and SCSI ID (for SCSI) or bus number and target
ID (for SATA/SAS) of each drive. The channel number or bus number
is always 1-based. The SCSI ID or target ID is always 0-based.
A list of integer values indicating that the nth
drive should be included in the array.
The keyword ALL to indicate that all remaining
drives attached to the controller that are not specified in previous
arrays must be included in the current array.
The first array must be labeled Array.A. Additional
arrays are labeled sequentially, Array.B, Array.C,
and so on. The maximum number of arrays allowed per controller is
determined by the limits of the specific RAID controller.
Example using channel number and SCSI ID:
Array.A = 1:1,1:2
Array.B = 1:3,1:4,1:5,2:1,2:2,2:3,2:4,2:5,2:6
Array.C = ALL